S-108-V1-EN
​
If your work limitations allow it, you can add breaks at the beginning or at the end of a duty, or before or after a pull in/out event. By default, the system does not allow this, but if you have very long depot pulls, it can provide more duty options and lead to a better solution.

For example, if you have a very long pull out event of 2 hours, and your driver is then scheduled to start a new trip which takes another 2 hours immediately after, they won't be able to take their break during these 4 hours. By using the Reposition preference, you will allow a break between the pull out and the first service trip, by moving the pull out so it will start slightly earlier.

See below a duty before using the reposition preference:
​

The same duty after allowing re-positioning of the pull event:
​

​

1. Open the preferences by clicking the preferences icon on the top left of the screen.
​

2. In the search bar, type 'Reposition Duty Start End Tasks For Breaks'
​

3. Click on 'Load Template' at the bottom of the pop-up screen, and choose the 'OPTIBUS' tab to see our example preferences. You can also use your own template if one has been saved in your tab.
​

4. Select 'Reposition Duty Start End Tasks For Breaks', and fill in the template's fields.

Minimal depot pull out - The minimum duration of a pull out from which you are allowing reposition.

Minimal depot pull in - The minimum duration of a pull in from which you are allowing reposition.
​